Real Time GPS Locator

Min Order

1
Product Unit

Pieces
Origin

China Mainland
Payment
Contact Now Start Order

Description

Product Detail

Parameter

Terminal Name: CA-V3

Product Type: Car GPS Tracker

GPRS: TCP/IP

Voltage input: DC12V/24V

Tracking accuracy: less than 10meters

Unit Weight: 56g

Terminal Size: 95mm(Length)*45mm(Width)*13.8mm(Height)

Working temperature: -20degrees to 70degrees

Working environment Humidity: 20% to 80% RH

Color: black

GSM Frequency: Quad band

Working consumption: 20mA@DC12V

Certificate: FCC CE

Battery: 180mAh

GSM Antenna: Inner

GPS Antenna: Ceramic

Product introduction:

CA-V3 GPS Tracker product uses 2G GSM module and UBLOX GPS module. So you need to insert 2G network SIM card and open GPRS function.

This terminal size is 95mm length, 45mm width and 13.8mm Height and working environment temperature is from -20degrees to 70degrees. The input voltage is from DC9V to DC39.9V.

Main Functions:

Item	Feature	Meaning
1	Cut engine	User can cut engine via platform or sending message to device. Vehicle will be shut down and theft can’t drive car away.( For safety considering, it will not cut engine while speed is above 20km/h)
2	Over voltage protection of Car Battery storage	This device with over voltage protection. To protect the device to be not damaged, this device will cut down the backup battery when input voltage is more than 40V.
3	Low voltage protection of Car Battery storage	This device with low voltage protection. The car battery storage voltage is less than9.5V when user is not using the car for long time. At this time, this device will cut down the backup battery automatically to save the car power for next using.
4	Built-in GPS GSM antenna	Built-in high tech of GPS?GSM antenna for easy installation.
5	Static state drifting protection	Most of device with static state drifting in the market,our device has applied new tech which can protect this problem nicely.

Product Picture:

SMS Commands:

1. Restore factory setting except IP

SMS Command format: #PASSWORD#FACTORY#

Reply: Resume factory parameter,OK!

It means restore settings to factory standard except IP and port data.

2. Re-start device

SMS Command format: #PASSWORD#reset#

Reply: start reset system, OK!

For example: #6666#reset#

Device will be re-started in 8-18seconds.

3. Cancel voice monitoring

SMS command format: #PASSWORD#CM#

4. Apply voice monitoring

SMS command format: #PASSWORD#OM#

5. Set Vibration alarm

SMS command format: #PASSWORD#SSA#LEVEL#

For example: #6666#SSA#1#, it means level is 1.

Reply: Set alarm level, OK!

6. Cancel Vibration

SMS command format: #PASSWORD#CSA#

For example: #6666#CSA#

Reply: Close vibration alarm, OK!

Power code wiring:

The standard voltage is DC9.5V to DC39.9V. Please use the power line which provided by the manufacturer. The red line is the positive. The black line is the negative. The negative should earth alone or link iron during installing. Do not connect it to other ground wire. And please make sure the device is powered on status. (Power switch on down position)

Red LED light will flash while device installed correctly, GSM blue LED light and GPS Green LED light will flash around 1 minute later after getting signal.